Guides to choosing industrial water treatment · Page 9
Find answers on selection, costs and operation: reverse osmosis, membranes, DAF flotation, solids separation and sludge dewatering.
View articlesArticles 145–162 of 170 · Newest first
Design and costs
Data to assess membrane wastewater treatment
Flow, analysis, variability and treatment targets needed for an initial UF, ceramic or reverse-osmosis assessment.
Read articleDesign and costsPreconcentration and evaporation: assess savings
Water balance, energy, capital and residues when assessing a membrane stage before an evaporator.
Read articleNanobubbles
Sizing a GENESIS™ nanobubble generator
Circuit flow, gas, pressure, water and process objective for choosing GENESIS™ without confusing device flow with total plant flow.
Read articleNanobubblesNanobubbles for membrane cleaning and backwash
Potential roles of nanobubbles in filtration and backwash, and a practical way to measure recovery without overextending experimental results.
Read articleNanobubblesNanobubbles: pressure, gas and operating flow
Plan nanobubble generation trials across gas, water and pressure settings without mistaking bubble counts for process performance.
Read articleNanobubblesNanobubbles and ozone: transfer and off-gas
Assess ozone and nanobubble contact by transfer, energy and oxidation results. Gas balances and criteria for comparing equipment.
Read articleNanobubblesNanobubbles in aeration: what to measure
Compare real oxygen transfer, reactor control and whole-line energy when assessing a nanobubble loop.
Read articleNanobubblesDAF nanobubbles: coagulant and polymer trials
Controlled comparison of separation, chemicals, sludge and energy when adding nanobubbles before a DAF.
Read articleNanobubblesNanobubbles and microbubbles: differences and uses
Size, generation and measurement differences between microbubbles and ultrafine bubbles, and how to assess their actual process effect.
Read articleReverse osmosis and reuse
Industrial RO concentrate: management options
Balance, characterisation and management routes for reverse-osmosis reject in industrial reuse.
Read articleReverse osmosis and reuseRecovered water for cooling towers: when to use RO
Makeup and blowdown balance, cycle chemistry and treatment choice for industrial cooling-water reuse.
Read articleReverse osmosis and reuseReverse osmosis with hot water: design and limits
Temperature, flux, salt passage, materials and heat balance when treating warm industrial water with RO.
Read articleReverse osmosis and reuseDairy water reuse: choosing UF, NF and RO
Separate product recovery from effluent treatment and choose membrane stages by fats, proteins, salts and final water use.
Read articleReverse osmosis and reuseReverse osmosis with high COD: pretreatment
Why COD alone does not set an RO feed limit and how to assess pretreatment, fouling, recovery and concentrate.
Read articleUF and concentration
UF before evaporation: when it adds value
Calculate when UF can reduce evaporator feed. Solids balances, permeate destinations and whole-train consumption.
Read articleUF and concentrationDigestate ultrafiltration: assessing feasibility
Feasibility checks for digestate UF: fibres, oils, viscosity, net flux, permeate quality and concentrate handling.
Read articleUF and concentrationCrossflow or dead-end UF: choosing for high solids
Compare solids accumulation, recirculation, energy and cleaning when treating high-load streams by ultrafiltration.
Read articleUF and concentrationDead-end UF with high solids: output and backwash
Cake build-up, backwashing and net output in dead-end UF of loaded water, with criteria for comparing pretreatment and crossflow.
Read articleGet a proposal for your project.
Tell us what you need to solve in your process. Start with the information you have.
We will review the application and explain the solution we can supply or the information needed to assess it.
Contactcomercial@neptunoes.comEmail water analyses, photographs and drawings to our sales address.