Concentration does not guarantee a draining structure
UF and mechanical disc separation use different surfaces and mechanisms. Material retained by a membrane is not necessarily retained between discs. The concentrate may contain fines and colloids that require a conditioning assessment. Do not assume that increasing concentration alone makes the material suitable for mechanical drainage or creates a handleable discharge.
The UltraFlux™ page includes solids concentration among its applications, subject to the water and project objective. This does not automatically validate a disc stage. Obtain trial material from the intended concentration regime, rather than using a less concentrated original feed.
Establish what the concentration figure means
Confirm whether analysis reports TSS, total solids or a specific fraction, and whether the basis is g/L or mass percentage. Avoid unit conversions that require an unknown density. Add apparent viscosity under relevant conditions, temperature and the behaviour of particles or flocs during transfer. These observations help explain drainage results.
Illustrative example: 2 m³/h of concentrate at 40 kg TSS/m³ carries 80 kg TSS/h. If a trial recovered 85%, the retained material would contain 68 kg TSS/h, leaving 12 kg TSS/h outside that discharge. This calculation establishes neither the filtrate flow nor the dryness or physical condition of the retained material.
Test drainage, capture and floc robustness
Observe whether the sample forms a permeable layer or a mass that rapidly restricts water passage. Where conditioning is proposed, test dose and mixing with a representative hydraulic route. Floc integrity on arrival at the machine matters as much as its appearance in a laboratory vessel before pumping or transfer.
Cover plausible concentrate levels and variations during UF operation. Measure recovered solids, separated liquid and discharge stability. If success requires a narrow condition, establish whether control or equalisation can maintain it. One favourable trial does not demonstrate unlimited tolerance to changes in source material, production campaign or concentration. Define the tested operating window explicitly.
Decide where the separated liquid goes
Returning filtrate to the UF circuit may recover particles but can also create an internal circulation that increases plant loading. Identify the return point and close an overall input-output balance. Do not present recycle as additional water recovery without accounting for its effect on hydraulic duty, solids loading and water quality.
Consider alternative conditioning, thickening or dewatering arrangements if discs do not produce useful outlets. The choice must meet solids-destination and liquid-management requirements with sustainable operation. Trials and an integrated balance must justify the product combination. Include chemical compatibility where conditioning is introduced.
Common questions
Does 40 g/L mean reagent-free dewatering is possible?
Concentration alone cannot establish that. Particle structure, drainability and the selected configuration determine conditioning requirements and the actual separation result.
Can all filtrate return to UltraFlux™?
That needs assessment. Return changes flow and loading and requires a coherent overall outlet or purge balance. Check reagent compatibility and circuit conditions as well.
