Begin with the destination of the material
Establish what happens after separation. Transfer into a mixed tank may require a pumpable stream, whereas removal in a container requires different physical behaviour. An arbitrarily high concentration can make transfer harder without adding useful value. Distinguish the required average concentration from the variation that the receiving system can tolerate.
Benenv describes separate thickening and dewatering configurations. Do not transfer a hydraulic-capacity entry from one duty to the other. Check which arrangement, feed and objective support the proposed figure, and require the quotation to identify the design conditions and the outcomes to be demonstrated for the selected machine.
Calculate hydraulic and dry-solids loading
Flow in m³/h multiplied by concentration in kg/m³ gives kg/h of dry material, provided the analytical basis is consistent. Numerically, 1 g/L equals 1 kg/m³. Do not interchange total solids and TSS without justification. The balance must follow the fraction that the separation duty is actually intended to recover.
Identify coincident peaks as well as averages. A high-flow dilute stream and a lower-flow concentrated batch may impose different constraints. Include both operating points. Equalisation can help, but the tank volume, mixing and control must be adequate for the variation that the proposed arrangement is expected to absorb.
Close a balance before comparing equipment sizes
Illustrative balance for retainable solids, with no added water: 10 m³/h at 10 kg/m³ contains 100 kg/h. Assume 90% capture, leaving 90 kg/h in the thickened stream. At an assumed outlet concentration of 50 kg/m³, that stream occupies 1.8 m³/h. These are example assumptions, not supplier performance data.
The separated liquid would be approximately 8.2 m³/h, carrying the remaining 10 kg/h: about 1.22 kg/m³. This assumes additive volumetric flows and densities close to water. The calculation demonstrates why volume reduction does not establish a load-free filtrate. Real design must account for measured concentrations, density and any added conditioning water.
Verify the complete operating window
For thickening, test concentration stability, pumping and response to feed changes. For dewatering, add discharge formation, adhesion, conveying and storage behaviour. Where conditioning is used, record active chemical dose and preparation. A result achieved with a defined chemical recipe does not describe reagent-free operation or performance under a different recipe.
Acceptance should cover sustainable flow, captured mass, liquid quality and continuity. Include startup, stoppages and low-loading conditions rather than only the most favourable test point. Document how operators will adjust the machine and which measured variable will warn that it is approaching a practical hydraulic or solids-loading limit.
Common questions
Does a higher outlet concentration always reduce cost?
No. It may save volume while making pumping harder or increasing conditioning and operator attention. Compare the complete system and the actual destination of the material.
Can I select the machine using m³/h alone?
No. Identical flow rates can carry very different dry loads and drain differently. Include concentration, variability and the required discharge condition.
