Solids separation

Why a 1 mm disc gap cannot predict TSS capture

A nominal disc gap is no guarantee of suspended-solids capture. Test particle shape, flocs, retained layers and the mass balance on representative feed.

Published Updated

Separate geometry from operating performance

Benenv lists a standard 1 mm gap for its disc family, with alternative spacings selected for particular applications. This does not establish an absolute particle-size cut. A slot is not a particle-size analysis, particularly when the feed includes fibres that can change orientation or soft flocs that can deform.

A particle has different dimensions in different directions. It may also break during pumping or deform under loading. Characterise the feed as it reaches the machine after relevant transfer operations. A sample collected before a high-shear pump or conditioning stage may not represent the material actually presented to the separation surface.

Account for the retained layer

University extension guidance and manure-separation research show that retained fibrous material can contribute to capture of smaller particles. This supports testing the whole system, rather than assigning a fixed additional removal percentage. The contribution depends on the feed and on whether the retained layer develops and remains stable.

Compare startup, established operation and a change in feed rate. Good capture after several minutes may coexist with losses during startup. Excessive accumulation may also reduce capacity or cause overflow. Both effects matter when a separator operates on short batches rather than a stable continuous feed over many hours.

Measure captured mass and liquid quality

A fall in concentration from feed to filtrate is not always the same as mass capture. Stream flows can differ and water may be added. Measure representative flow and TSS data, and distinguish TSS from total solids. Dissolved material included in total-solids analysis does not behave like mechanically retained particles.

Illustrative example: 20 m³/h at 3 kg TSS/m³ carries 60 kg TSS/h. If retained material contains 42 kg TSS/h and the balance closes, capture is 70%. That result comes from measured masses, not from a 1 mm gap. It also makes no assumption about the final discharge dryness.

Make the trial repeatable

Record spacing, rotation setting, feed level, duration, temperature and conditioning. Cover relevant production variations and inspect drainage and the retained discharge. Where polymer is used, document preparation, active dose and mixing. Flocs formed successfully in a laboratory vessel may not survive the route from the conditioning point to the machine.

Agree acceptance criteria before testing: captured mass, filtrate TSS, sustainable flow and discharge handling. Repeat important operating points and record analytical uncertainty. This permits a meaningful comparison of configurations without mistaking a favourable sample for proof that the machine can process every feed condition throughout the production campaign.

Common questions

Will a smaller gap always improve the process?

It may improve retention of some fractions but can also restrict capacity or drainage. Balance capture against stable operation and the needs of the next process.

Is a visually clear filtrate enough evidence?

No. Appearance does not quantify TSS or dissolved pollution. Measure the parameters governing the liquid destination and close the solids balance.

Sources and documentation

Your project with Neptuno

Get a proposal for your project.

Tell us what you need to solve in your process. Start with the information you have.

We will review the application and explain the solution we can supply or the information needed to assess it.

Contactcomercial@neptunoes.comEmail water analyses, photographs and drawings to our sales address.
TECHNICAL CONTACT

Tell us about your project.

Tell us what you need and we’ll propose a solution.

Add process details (optional)

NEPTUNO WATER TECHNOLOGY SL will use your details to handle the enquiry. Your rights and further information are in the privacy policy.