Solids separation

Wave separator settings: balance throughput, capture and dryness

Assess oval-disc wave separator speed and back pressure using throughput, solids capture and discharge concentration measured in the same trial.

Published Updated Prepared by Neptuno Water Technology

Identify the actual machine duty

Here, wave separator means a mechanical oval-disc separator rather than a disc-stack centrifuge. Before adjusting, establish whether the configuration screens, thickens or dewaters with a pressure plate. Each duty requires a different assessment of the retained material.

Screening may be judged by fibre recovery and continuous discharge. Thickening also requires a transferable outlet concentration. Dewatering adds cake handling to the assessment. Capacities published for different duties should not be compared as if they described the same operating requirement.

Understand the transport and compression trade-off

Kendensha describes higher speed and lower pressure as favouring throughput, while reduced speed and increased pressure can favour dryness in its equipment. This supports a trial approach rather than transferable setpoints, operating limits or guaranteed results for another manufacturer.

The manufacturer also notes that excessive pressure on some oily sludge can increase solids passing into filtrate. A drier cake therefore needs to be assessed alongside capture. Actual response remains material-specific and should be measured after operation has stabilised.

Keep the feed basis consistent

Record flow, concentration and batch changes. Document chemical preparation and allow stabilisation after each adjustment. Changing polymer, feed and pressure together prevents the trial from identifying which variable caused the observed response.

Identify washing and dilution streams as well. Filtrate made visually clearer by additional water does not establish better capture. Compare mass flows rather than appearance, and collect feed, retained solids and liquid samples over equivalent periods.

Record three outcomes at each trial point

For each setting record feed dry-solids loading, the fraction recovered and discharge concentration. Add active polymer dose, energy, adjustments and observations on continuity. The final destination may give one outcome more weight, but the other two must remain visible.

Illustrative comparison without predicted performance: at equal captured dry mass, changing cake solids from 20% to 25% reduces wet cake mass by 20%. If capture changes, this no longer compares the same separation result; recalculate the complete balance instead.

Choose the operating point that meets the process objective

Define acceptable filtrate loading, working hours and discharge handling. Compare disposal, reagent and operating costs against those requirements. Do not treat an untested cake-solids target or separated-liquid quality as an established result.

Ask the proposal to identify configuration, materials, disc gap and auxiliary scope. For fine sludge, the geometric opening alone cannot predict capture. Conditioning and floc behaviour may govern whether the proposed operating point is useful for the plant.

Sources and documentation

Your project with Neptuno

Get a proposal for your project.

Tell us what you need to solve in your process. Start with the information you have.

We will review the application and explain the solution we can supply or the information needed to assess it.

Contactcomercial@neptunoes.comEmail water analyses, photographs and drawings to our sales address.
TECHNICAL CONTACT

Tell us about your project.

Tell us what you need and we’ll propose a solution.

Add process details (optional)

NEPTUNO WATER TECHNOLOGY SL will use your details to handle the enquiry. Your rights and further information are in the privacy policy.