DAF flotation

Free or emulsified oil: what changes before a DAF

Distinguish free, dispersed and emulsified oil when planning DAF trials, upstream gravity separation and evidence-based chemical conditioning.

Published Updated

Identify how the oil is present

A layer forming at rest indicates a gravity-separable fraction. Fine dispersed droplets or detergent-stabilised emulsions may coexist with it. Combine visual inspection with analysis and an operating history to distinguish these forms.

Record the oil source, cleaning products, pH, temperature and passage through pumps or mixers. This information helps explain why wastewater that previously formed a surface layer now stays cloudy. Not all cloudiness is oil, and not all oil is visible as a floating layer.

Consider upstream collection of a free-oil fraction

The UFC operating manual describes gravity oil-water separation ahead of flotation for removing free oil. FAO guidance also distinguishes oil and fat separation mechanisms. Justify this sequence for the actual wastewater: it can avoid assigning a readily collectable upstream load unnecessarily to the DAF.

A tank needs suitable inlet conditions, residence time, surface collection and sediment withdrawal. Stable emulsions may pass through. Upstream collection aims to remove an identified fraction; standing time does not resolve every emulsion.

Demonstrate destabilisation before increasing air

DAF helps droplets and aggregates rise when they can associate with bubbles. If an emulsion remains stable, increasing air or pressure does not establish that it will separate. Trials should investigate conditioning and then demonstrate flotation, distinguishing aggregate formation from the subsequent physical separation step.

Compare pH, coagulant and flocculation conditions through controlled tests on actual wastewater. Record quantities, addition sequence and mixing to make results interpretable. Chemical selection also needs to consider compatibility, sludge production and downstream treatment. This article does not prescribe a universal chemical, dose or operating adjustment.

Evaluate removal on a consistent basis

Analyse oil and grease in the feed and clarified water using a method appropriate to the matrix, and examine the collected float. A reduction in turbidity does not establish an identical reduction in oil. COD can include detergents and dissolved substances that do not leave with the captured oil.

If free and emulsified oil coexist, removal measured for the free fraction cannot be applied to the total. Measure the complete mixture after the proposed sequence, including upstream separation where specified.

Check the response to cleaning events

A successful test on production wastewater does not automatically validate end-of-shift cleaning. Detergents and temperature changes can alter emulsion behaviour. Repeating the assessment on representative events helps determine whether equalisation, segregation or additional operating flexibility is needed, rather than depending on one favourable laboratory condition.

Establish pumping, storage and treatment of separated oil or sludge, including liquid returns. Separating an emulsion does not remove every dissolved constituent or establish suitability for unrestricted water reuse.

Common questions

Does adding more air break an emulsion?

Do not assume so. Air promotes flotation of separable material; a stable emulsion may need demonstrated conditioning before it can associate effectively with bubbles.

Does a visible oil layer mean gravity separation is sufficient?

It shows a free-oil fraction exists, but dispersed or emulsified oil may remain. Measure the residual after that layer has been removed.

Sources and documentation

Your project with Neptuno

Get a proposal for your project.

Tell us what you need to solve in your process. Start with the information you have.

We will review the application and explain the solution we can supply or the information needed to assess it.

Contactcomercial@neptunoes.comEmail water analyses, photographs and drawings to our sales address.
TECHNICAL CONTACT

Tell us about your project.

Tell us what you need and we’ll propose a solution.

Add process details (optional)

NEPTUNO WATER TECHNOLOGY SL will use your details to handle the enquiry. Your rights and further information are in the privacy policy.