DAF flotation

Fish-processing DAF: account for salinity, fats and production changes

What to measure for fish-processing DAF: fats, suspended solids, brines, species changes and the dissolved organic load that flotation leaves behind.

Published Updated

Different production campaigns create different wastewater

Filleting, cooking, preservation and cleaning produce different streams. Tissue, fats, proteins, flow, temperature and species can change. FAO highlights this diversity. One favourable sample leaves difficult operating periods untested.

A stream map helps establish what will be combined and what deserves separate assessment. Include brine discharges, seawater use, rinses and treatment returns. Record production and water consumption so an increase in concentration can be distinguished from an increase in the mass reaching the plant.

Keep salts and separable material distinct

Flotation requires a phase that can aggregate and associate with bubbles. Dissolved ions in a brine are not removed by that mechanism. Conductivity is useful for tracking saline events, but converting it directly into a salt concentration requires a valid relationship for the particular composition and temperature.

Illustrative example: 100 m³/day containing 5 g/L dissolved salts carries 500 kg salts/day. Removing suspended solids and fats through DAF does not automatically remove that dissolved mass. Where salinity constrains biological treatment or the destination of the water, a specific segregation or treatment strategy is needed.

Test the actual mixture, including its salinity

Use actual feed water and record conductivity, pH and temperature. Original seawater experiments found changes in microbubbles and hydraulic behaviour compared with distilled water. They do not predict this wastewater’s performance, but reinforce the need to test its actual salinity rather than transfer freshwater results.

Measure solids, fats and total/filtered COD in the feed and clarified water, and examine the collected float. FAO also identifies chloride interference in certain COD analyses. Tell the laboratory about the saline matrix so it can select an appropriate method and report the limitations of the results.

Capture production and cleaning transitions

Assess equalisation against actual schedules and discharge volumes. A brief wash-down may coincide with sludge-handling returns or a brine release. The important condition is the combined effect on flow, pH and load, rather than an indiscriminate combination of every maximum recorded during the week.

Recovering tissue and fats before the drain reduces load. Consider upstream collection of free oil; stable emulsions need demonstrated conditioning. DAF replaces neither coarse screening nor assessment of subsequent treatment.

Specify both water and sludge destinations

State what the clarified water must achieve: feeding a biological stage, reducing a particular load or preparing for another process. Good solids separation alone does not establish suitability for reuse, salt removal or complete COD removal. Each of those objectives needs its own supporting data.

Sludge varies with fat, tissue and conditioning chemicals. Check withdrawal, storage and dewatering to prevent interruptions. Trials should include conditions likely to determine those capacities rather than only the easiest product run.

Common questions

Will DAF lower the salinity of fish-processing wastewater?

It does not directly remove dissolved salts. It can separate particulate contamination while salinity remains, so these fractions require different assessments.

Can the same settings be used for every species?

Do not assume so. Changes in fat, protein, temperature, salinity and cleaning justify checking the process against representative mixtures from each campaign.

Sources and documentation

Your project with Neptuno

Get a proposal for your project.

Tell us what you need to solve in your process. Start with the information you have.

We will review the application and explain the solution we can supply or the information needed to assess it.

Contactcomercial@neptunoes.comEmail water analyses, photographs and drawings to our sales address.
TECHNICAL CONTACT

Tell us about your project.

Tell us what you need and we’ll propose a solution.

Add process details (optional)

NEPTUNO WATER TECHNOLOGY SL will use your details to handle the enquiry. Your rights and further information are in the privacy policy.