DAF flotation

DAF with detergents: assessing foam and emulsions in laundry and textiles

Plan DAF treatability tests for laundry and textile wastewater containing surfactants, foam, emulsified oils, colour and soluble COD.

Published Updated

Distinguish foam from collected contamination

Foam is a gas-and-liquid structure; useful float contains the contaminants intended for removal. A large surface layer may carry little dry solid material. Measure solids and the volume of the withdrawn stream rather than judging performance from its height or appearance alone.

EPA textile guidance describes surfactants used as detergents, emulsifiers and dispersants. Some of the associated load may remain dissolved. Residual colour or COD cannot therefore be explained solely by the suspended solids the DAF can capture, even when the water looks clearer.

Identify the recipes entering the drain

Record detergents, softeners, oils, finishing chemicals and wash sequences to explain changes in response. A detergent trade name does not describe the complete mixture: obtain relevant technical information and determine how much actually reaches the wastewater rather than assuming the full production dose is discharged.

For textiles, distinguish concentrated baths from rinses; for laundry, separate normal operation from unusually soiled loads. A daily composite helps establish a mass balance, but may not reproduce a brief discharge with particularly persistent foam or a stable oil emulsion. Include such events in the trial plan.

Demonstrate flotation, not just floc formation

A coagulation test that forms visible floc is not sufficient evidence of DAF separation. Check association with microbubbles, clarified-water quality and float stability. Compare equivalent samples while recording mixing, pH and chemical addition sequence so the reason for any improvement can be assessed.

If an antifoam is being considered, include it in the complete test and examine its effects on separation and subsequent treatment. Suppressing visible foam does not prove COD reduction or emulsion breaking. Chemical selection and dosage cannot be established without understanding the wastewater matrix.

Do not assign all COD to the floatable fraction

Illustrative example: wastewater with 1,200 mg/L total COD and 900 mg/L filtered COD has a difference of 300 mg/L. Even hypothetical complete removal of that difference would leave 900 mg/L. The filtered fraction is not automatically biodegradable, and this example predicts no DAF removal rate. This assumes the filtered fraction remains unchanged; it is not a minimum effluent COD, because some fine filter-passing colloids may respond to coagulation and flotation.

The difference also does not establish that all 300 mg/L is floatable. Measure COD, solids and oils before and after treatment to establish the actual response. Where the objective includes colour or dissolved compounds, assess those explicitly; a different or additional treatment step may be needed.

Select for stable operation and manageable residues

Comparing normal production, recipe changes and cleaning supports decisions on equalisation or separate stream management. Record flow, temperature and conductivity to identify the event changing the chemistry, rather than repeatedly treating only the symptom visible at the tank surface.

Finally, check sludge pumping, storage and dewatering behaviour. A trial delivering clear water but uncontrollable foam or residue that cannot be withdrawn reliably needs further development before its results become an equipment purchase specification. Include representative operating transitions in that assessment.

Common questions

Does a lot of foam mean the DAF is working well?

No. Measure residual contamination and captured dry solids. Abundant foam may contain little removed material and can make collection more difficult.

Will DAF remove every detergent and all colour?

That cannot be assumed. Removal depends on the fractions present and their conditioning; dissolved material requires specific evaluation and may need additional treatment.

Sources and documentation

Your project with Neptuno

Get a proposal for your project.

Tell us what you need to solve in your process. Start with the information you have.

We will review the application and explain the solution we can supply or the information needed to assess it.

Contactcomercial@neptunoes.comEmail water analyses, photographs and drawings to our sales address.
TECHNICAL CONTACT

Tell us about your project.

Tell us what you need and we’ll propose a solution.

Add process details (optional)

NEPTUNO WATER TECHNOLOGY SL will use your details to handle the enquiry. Your rights and further information are in the privacy policy.