Sludge dewatering

Calculate wet sludge cake tonnes from dry solids

Convert captured dry solids and cake solids percentage into wet tonnes, then assess water reduction against a consistent capture basis.

Published Updated

Separate wet mass, dry solids and volume

Dry solids refer to the residue determined by the agreed laboratory method. Wet cake mass includes that residue and the water remaining with it. Cake containing 20% solids by mass has 200 kg of dry solids in every 1,000 kg of wet material.

The solids percentage does not directly provide cake volume. Container sizing requires representative bulk density and allowance for the way cake falls, packs and fills the container. Do not automatically convert wet tonnes into cubic metres using the density of water.

Calculate the solids actually captured

Illustrative example: 100 m³/day of sludge containing 15 kg DS/m³ supplies 1,500 kg DS/day. Assuming 96% capture, the cake receives 1,500 × 0.96 = 1,440 kg DS/day. The remaining 60 kg/day must be accounted for in filtrate and other outlets.

The assumed capture is an input to this calculation, not a guaranteed result. For an actual comparison, measure feed, cake and losses over matching periods. Record chemicals that add solids and changes in the material inventory held within the dewatering system.

Compare two cake concentrations on the same basis

With 1,440 kg DS/day captured, cake at 18% solids produces 1,440 / 0.18 = 8,000 kg wet cake/day. At 24%, it produces 1,440 / 0.24 = 6,000 kg/day. The difference is two wet tonnes per day, or a 25% reduction relative to the original eight tonnes.

Water retained in the cake falls from 6,560 to 4,560 kg/day; the captured dry-solids mass stays at 1,440 kg/day. Both cake concentrations are illustrative assumptions. They do not describe a result attainable with every sludge or a particular press.

Translate the balance into collection arrangements

Calculate production between collections, including days without transport, and compare it with the container’s permitted weight and usable volume. Drier cake can still fill a container before reaching its weight limit, particularly when it accumulates unevenly beneath the discharge point.

Where a proposal predicts fewer truck movements, check payload, collection schedules, partial loads and the waste contractor’s constraints. Lower wet mass does not necessarily reduce journey numbers when collections follow a fixed timetable or are combined with other waste streams.

Evaluate dryness alongside the operating point

Producing drier cake may change throughput, polymer consumption or solids capture. Compare alternatives for the same daily dry-solids load and available processing hours. Confirm that the resulting cake discharges and can be handled reliably: a laboratory solids percentage does not fully describe its practical behaviour.

Common questions

Does increasing cake solids from 18% to 24% reduce cake mass by 6%?

No. At constant captured dry solids, wet mass is multiplied by 18/24, giving a 25% reduction. Six percentage points of solids are not a 6% mass reduction.

Is the driest cake always the best choice?

The result depends on capacity, chemicals, capture and collection arrangements. Compare the complete operation at an equivalent sludge loading.

Sources and documentation

Your project with Neptuno

Get a proposal for your project.

Tell us what you need to solve in your process. Start with the information you have.

We will review the application and explain the solution we can supply or the information needed to assess it.

Contactcomercial@neptunoes.comEmail water analyses, photographs and drawings to our sales address.
TECHNICAL CONTACT

Tell us about your project.

Tell us what you need and we’ll propose a solution.

Add process details (optional)

NEPTUNO WATER TECHNOLOGY SL will use your details to handle the enquiry. Your rights and further information are in the privacy policy.