Sludge dewatering

Oily DAF float: when to trial a screw press

Assess oily DAF sludge through characterisation, drainage tests and representative press trials without assuming a universal cake-solids result.

Published Updated Prepared by Neptuno Water Technology

Characterise the float, not only the treated water

DAF effluent analysis does not fully describe the sludge. Take representative samples from the float collection stream and measure solids, oil and grease, pH, temperature and composition changes. Identify coagulants, polymers and cleaning discharges reaching the process.

Distinguish free oil, emulsified material and grease associated with particles. Experimental research on floated oily sludge shows that changing emulsion structure can alter dewaterability. It does not demonstrate that a particular press will handle every emulsion or justify copying laboratory chemical treatments into a plant.

Use mass loading and a defined feeding condition

Collected float can contain air and show variable apparent volume or density. An isolated volume reading is insufficient for equipment selection. Establish representative concentration and daily mass, then define storage and feeding arrangements that avoid uncontrolled phase separation.

Illustrative calculation: 50 m³/day containing 12 kg DS/m³ represents 600 kg DS/day. Processing it in six net hours requires 100 kg DS/h and 8.33 m³/h. This assumes representative volume and concentration; it is not an oily-sludge capacity statement for any press model.

Test drainage and resistance to process stresses

Begin with correctly prepared polymer candidates. Compare drainage, solids losses and floc stability following representative mixing. Observe whether the material becomes a poorly draining paste or produces a separated oil phase that complicates collection and handling.

Then validate dry-solids throughput, capture, cake solids and continuous discharge in a press trial. Include difficult production conditions that can recur, rather than testing only the easiest float to process. Trial temperature should reflect the intended operating conditions, including relevant seasonal or production changes.

Assess the outlets and compatibility of the system

Analyse filtrate to establish what returns to the water-treatment line. Alongside suspended solids, it may carry oil, soluble material and chemicals. Low suspended-solids concentration does not establish suitability for discharge or reuse. Define its destination before completing equipment selection.

Check material compatibility, pumping behaviour and the residue’s safety requirements. Where a recoverable free-oil fraction exists, upstream recovery may merit assessment. Do not add a chemical stage solely to reach a cake-solids target without considering the consequences for all outlet streams.

Make a decision within demonstrated limits

A useful trial establishes an operating window and identifies when requirements cease to be met. If the float will not drain or requires impractical conditioning, compare another handling or dewatering route. No single oil-content threshold determines suitability for every sludge. Preserve the tested feed conditions so a later recipe or production change triggers a reasoned review.

Common questions

Can every multi-disc press process any oily sludge?

No. The equipment name does not establish tolerance to emulsions, viscosity or composition. Require validation using representative samples.

Should the dewatering trial use raw DAF inlet water?

Press selection needs the collected float that will actually be fed to it. Raw wastewater testing answers a different process question.

Sources and documentation

Your project with Neptuno

Get a proposal for your project.

Tell us what you need to solve in your process. Start with the information you have.

We will review the application and explain the solution we can supply or the information needed to assess it.

Contactcomercial@neptunoes.comEmail water analyses, photographs and drawings to our sales address.
TECHNICAL CONTACT

Tell us about your project.

Tell us what you need and we’ll propose a solution.

Add process details (optional)

NEPTUNO WATER TECHNOLOGY SL will use your details to handle the enquiry. Your rights and further information are in the privacy policy.