Solids separation

Disc separator or DAF: different mechanisms, possible partners

Distinguish mechanical retention from flotation when comparing discs and DAF. Assess solids fractions, fats, conditioning and the destination of separated sludge.

Published Updated

Identify the fraction requiring separation

Fibres and debris that a surface can physically retain create a screening duty. Fine particles, light flocs and some fatty material may require a different separation mechanism. Identify these fractions and their loadings. A single TSS concentration does not describe particle morphology, buoyancy, adhesion or response to chemical conditioning.

Distinguish free fats, material associated with particles and emulsions. Do not assume that discs retain every fatty fraction or that adding air resolves every emulsion. Conditioning may be necessary and should be tested under representative production, pH and temperature conditions. Include changes associated with cleaning and product recipes.

Understand what each mechanism contributes

In the supplier-described disc arrangement, liquid drains between elements while retained material advances. DAF generates microbubbles by releasing pressure from water containing dissolved gas, allowing suitable aggregates to float. These mechanism descriptions do not guarantee removal from a particular wastewater or establish the conditions needed to achieve it.

Upstream screening may remove a coarse fraction before DAF where that provides an operational benefit. The flotation stage can then address material not retained by that screen. Assess whether this sequence is worthwhile: two stages also mean additional equipment, discharge interfaces and operating requirements. More equipment is not automatically a better treatment train.

Compare the loads and both separated streams

When testing a sequence, measure each stream so removal is not counted twice. Screen capture refers to its feed, while downstream DAF capture refers to a different feed. Report overall removal relative to the raw wastewater as well as stage results and the mass of material requiring separate management.

Include the floated sludge in the assessment. Its volume, concentration, conditioning and downstream treatment are part of the solution. Good water quality may be impractical if sludge storage or dewatering capacity is missing. Also determine the soluble loading that remains for biological treatment or another downstream operation after physical separation.

Test the minimum useful combination

Run a mechanical-retention trial and, where relevant, coagulation, flocculation and flotation tests. Define the quality required by the next process. Compare chemical consumption, recycle requirements, energy and solids handling using the same system boundary rather than relying on isolated removal percentages. Specify the duration and feed conditions behind each result.

Cover cleaning events and product changes. A robust arrangement must accommodate the events that govern operation, not only average feed. Agree which adjustments are permitted and what observations would trigger reconsideration of the sequence, greater equalisation or separate collection of a particular wastewater at its source. These decisions should precede equipment commitment.

Common questions

Does DAF always replace screening?

No. Coarse debris or fibres may need separate removal to protect equipment. The requirement depends on the wastewater and the specific flotation-system design.

Do discs remove soluble COD?

Mechanical retention does not establish removal of dissolved substances. Analyse the soluble fraction and its downstream treatment; TSS removal does not mean that all COD has been removed.

Sources and documentation

Your project with Neptuno

Get a proposal for your project.

Tell us what you need to solve in your process. Start with the information you have.

We will review the application and explain the solution we can supply or the information needed to assess it.

Contactcomercial@neptunoes.comEmail water analyses, photographs and drawings to our sales address.
TECHNICAL CONTACT

Tell us about your project.

Tell us what you need and we’ll propose a solution.

Add process details (optional)

NEPTUNO WATER TECHNOLOGY SL will use your details to handle the enquiry. Your rights and further information are in the privacy policy.