DAF flotation

Water temperature in DAF: air solubility and treatability

Account for cold water, hot cleaning discharges and seasonal variation when assessing dissolved air, flocculation and the real operating envelope of a DAF.

Published Updated

Measure process-water temperature rather than ambient air

Record temperature in the feed and recycle circuit alongside production, flow and cleaning activity. A hot discharge may be short but coincide with a significant loading event. A daily mean or building temperature can conceal the episode that constrains the equipment. Keep temperature records aligned with the corresponding water-quality samples.

Consider what happens during sample transport. Testing at room temperature when the plant receives much colder or warmer water changes the condition being assessed. The report should state sampling, storage and test temperatures, and distinguish temperature variation from simultaneous composition changes. Sample identity alone does not establish representativeness.

Separate equilibrium solubility from saturator operation

Equilibrium solubility describes a limit under defined pressure, temperature and composition. Actual dissolved-air delivery also depends on contact and the way the equipment operates. A single thermal correction percentage should therefore not be applied indiscriminately to every saturator and wastewater. Confirm correction assumptions before equipment selection.

Research on operating saturators distinguishes equilibrium from gas transfer under non-equilibrium conditions, where temperature response can differ. Treat that distinction as a reason to measure and verify rather than copying a published optimum temperature. Salinity introduces another variable that needs to remain identifiable when comparing different test conditions.

Check mixing and separation as well as air

Temperature changes water viscosity and can affect aggregate formation and movement. In industrial wastewater it may also coincide with changes in the physical state of fats or process chemistry. Observe those effects and establish their relevance to the actual sample before attributing deterioration solely to a shortage of dissolved air.

Compare clarified-water quality, fines, separation rate and float condition at representative temperatures. Use one series with constant chemistry to examine sensitivity, and another with controlled adjustments where an operating response needs to be developed. This distinguishes a diagnostic comparison from optimization and makes the resulting recommendations easier to interpret.

Translate thermal variation into the equipment duty

Include minimum, normal and maximum temperatures, event durations and rate of change where relevant. Check materials, equipment limits and instrumentation with the supplier. For recycle pumps, hot-water conditions also belong in the suction assessment; flotation performance is not the only aspect of the package that needs verification under the thermal duty.

A pilot should examine plausible combinations of temperature and production. Do not automatically declare summer or winter the worst case for the complete process. Where a seasonal condition cannot be reproduced, identify that uncertainty and define the additional testing or selection condition needed before the final equipment choice is closed.

Common questions

Does colder water always improve DAF performance?

No. It can favour air solubility, while viscosity, flocculation and feed composition also affect separation. Verify the complete result using the intended chemistry and configuration.

Can hotter water simply be compensated by higher pressure?

That requires evaluation. Check equipment ratings, actual dissolution and other circuit constraints. Any setting change needs validation within the documented operating limits of the complete assembly.

Sources and documentation

Your project with Neptuno

Get a proposal for your project.

Tell us what you need to solve in your process. Start with the information you have.

We will review the application and explain the solution we can supply or the information needed to assess it.

Contactcomercial@neptunoes.comEmail water analyses, photographs and drawings to our sales address.
TECHNICAL CONTACT

Tell us about your project.

Tell us what you need and we’ll propose a solution.

Add process details (optional)

NEPTUNO WATER TECHNOLOGY SL will use your details to handle the enquiry. Your rights and further information are in the privacy policy.