DAF flotation

DAF recycle pumps: selection, air ingress and cavitation

Specify a DAF recycle pump using its duty point, suction conditions, NPSH, intended gas handling and practical acceptance checks.

Published Updated

Define the complete pumping duty

Provide minimum, normal and maximum flow, required circuit pressure and anticipated head losses. Include suction-tank levels, temperature, liquid composition and changes in operation. Identify pressure-measurement positions and the components included in the saturation package. An incomplete boundary can leave an important restriction outside both suppliers’ selection assumptions.

Request the pump curve, efficiency, absorbed power and operating limits at the proposed conditions. Installed motor power or a catalogue maximum pressure does not define the duty point. Check how speed or flow control changes that point and how the proposed control interacts with the saturator and pressure-release devices.

Compare net positive suction head (NPSH)

Available NPSH belongs to the installation; required NPSH belongs to the pump and varies with operation. Cavitation involves vapour formation and collapse when local pressure is insufficient. Request the check at minimum supply level, maximum expected temperature and the suction losses corresponding to the flow being assessed.

Illustrative arithmetic: 4.5 m available against 3.2 m required leaves a difference of 1.3 m. This alone does not establish an adequate margin. The supplier must justify the margin and curve basis for the duty. Also examine what happens when suction losses increase or the water level falls below the normal operating point.

Distinguish accidental air from designed gas dissolution

Inspect for intake vortices, inadequate submergence, air entry at joints and gas carried into the pump with clarified water. These are inspection hypotheses, not diagnoses established by noise alone. A pump can operate unstably with entrained air without that phenomenon being identical to vapour cavitation. Record the conditions supporting the diagnosis.

Some DAF packages use equipment specifically designed to handle and dissolve gas. That function should be declared in the documentation. Do not turn an ordinary centrifugal pump into a dissolution system by introducing air at its suction without a specific manufacturer selection and assessment of the complete package and its operating controls.

Make procurement and acceptance measurable

Include materials, sealing, maintenance access, instrumentation and protection against unsuitable operation in the specification. Where relevant, ask suppliers to distinguish water-only performance from gas-handling conditions. The proposal should identify the equipment and configuration supporting the intended air-production duty as well as the required recycle-water flow through the circuit.

At acceptance, compare measured flow, pressures, consumption and stability against recorded supply conditions. Check water level and temperature during the test. If noise or vibration occurs, preserve trends and examine suction conditions and duty point before changing settings. Discharge pressure alone does not complete circuit acceptance.

Common questions

Is available NPSH greater than required NPSH sufficient?

A justified margin is also needed for the application and curve basis. Request that assessment from the supplier; a positive difference alone does not establish reliable service.

Does a gravel-like noise always mean cavitation?

It is a reason to investigate. Air, wear and other problems can create similar symptoms. Compare pressures, water levels and actual operating conditions before drawing a conclusion.

Sources and documentation

Your project with Neptuno

Get a proposal for your project.

Tell us what you need to solve in your process. Start with the information you have.

We will review the application and explain the solution we can supply or the information needed to assess it.

Contactcomercial@neptunoes.comEmail water analyses, photographs and drawings to our sales address.
TECHNICAL CONTACT

Tell us about your project.

Tell us what you need and we’ll propose a solution.

Add process details (optional)

NEPTUNO WATER TECHNOLOGY SL will use your details to handle the enquiry. Your rights and further information are in the privacy policy.