DAF flotation

DAF bottom solids: grit, deposits and withdrawal

DAF can accumulate settled material as well as surface float. Characterize deposits, provide effective bottom withdrawal and include them in the solids balance.

Published Updated

Identify the material reaching the floor

Sample the deposit and incoming feed representatively. Distinguish mineral material, precipitates, process debris and floc that has lost flotation response. Appearance helps direct the investigation, but cannot replace particle size, concentration or composition where these determine abrasion, disposal or downstream treatment requirements. Retain sampling locations and dates with the results.

Record where deposits appear and when: during production, after cleaning or following shutdown. Location and timing help compare hypotheses involving distribution, dense incoming particles or loss of separation. Do not assume every deposit means insufficient coagulant. First compare the operating conditions and the nature of the material observed.

Specify withdrawal that reaches the deposit

Bottom withdrawal can use hoppers, collectors, scrapers or other devices appropriate to the geometry. Request a drawing showing how solids reach the discharge point, rather than simply confirming that a drain valve exists. A connection remote from the accumulation does not establish that the floor will clear effectively.

Check passage dimensions, access, relevant slopes and the destination of each withdrawal stream. Pipework must suit the actual solids and concentration. Establish how discharge is confirmed rather than relying only on valve-open time: an actuated valve can operate while the connected line remains obstructed. Include practical inspection in the proposed arrangement.

Measure extracted solids and associated water

Record withdrawal frequency, duration, volume and dry-solids content. Excessive continuous discharge can send unnecessary water to sludge treatment; insufficient withdrawal allows an inventory to accumulate. Adjustment requires observation and measurement rather than a universal purge frequency. Compare conditions over a period long enough to reveal accumulation between discharges.

Illustrative one-hour balance: 50 kg of solids enter; 40 kg leave as float, 5 kg through bottom withdrawal and 3 kg in the effluent. The remaining 2 kg may represent accumulation or measurement uncertainty. Do not automatically label all 47 kg missing from the effluent as solids recovered by the surface collection system.

Address the source before fixing the design

Where a substantial mineral fraction arrives, investigate its source and whether upstream removal is appropriate. The decision depends on loading, particle size, variability and process layout. A flotation unit should not automatically take over every pretreatment function. Compare proposed materials and maintenance provisions with the expected abrasive duty as part of selection.

Include bottom inspection and a withdrawal demonstration under representative conditions in acceptance. Document draining, cleaning and inspection arrangements, including recovery after shutdown. Where sludge liquors are returned upstream, identify the return point and solids contribution so that withdrawn material does not reappear in the feed without being accounted for.

Common questions

Does a deposit prove that the wrong DAF was selected?

Not necessarily. A settleable fraction may be anticipated in the design. The issue is whether its quantity, withdrawal route and operational effects are characterized and accommodated.

Should bottom sludge always be mixed with surface float?

Not automatically. Concentration, abrasiveness and handling behaviour can differ. Compare combined and separate handling against the proposed sludge-treatment arrangement.

Sources and documentation

Your project with Neptuno

Get a proposal for your project.

Tell us what you need to solve in your process. Start with the information you have.

We will review the application and explain the solution we can supply or the information needed to assess it.

Contactcomercial@neptunoes.comEmail water analyses, photographs and drawings to our sales address.
TECHNICAL CONTACT

Tell us about your project.

Tell us what you need and we’ll propose a solution.

Add process details (optional)

NEPTUNO WATER TECHNOLOGY SL will use your details to handle the enquiry. Your rights and further information are in the privacy policy.